Pre-Installation Preparation; Door Operation; Rear Exit; Top Vent - Napoleon BGD36CFNTR Installation And Operation Manual

pre-installation preparation

4.0 pre-installation preparation
EN
WARNING
!
• Failure to create a seal to the fi rebox with the exhaust collar assembly will cause the appliance to function
improperly and can cause injury or property damage.
4.1

door operation

Release the top and bottom door latches, located at the right side of the door.
4.2

rear exit

From inside the fi rebox, insert the 4" (10.2cm) fl ue pipe / gasket assembly (provided)
through the rear of the fi rebox. Secure the gasket assembly to the rear and top of the
appliance using 4 #8 x ¾ inch Hex Head Wildrill screws supplied.
Do not overtighten. The gasket needs only to be snug against the fi rebox.
Before attaching elbows to the collars on the back of the appliance, 1½" (38mm) will
need to be trimmed off the 4" (10.2cm) collar.
4.3

top vent

A. Remove the 7" (17.8cm) diameter cap from the top of the appliance and re-secure it over the 7" (17.8cm)
collar located at the rear of the appliance. Press fi rmly on the cap while
securing to ensure an airtight seal. Do not damage the gasket.
B. Remove the plate covering the 4" (10.2cm) diameter fl ue opening (seen inside
the top of the 7" (17.8cm) diameter collar) and discard. Try not to disturb the
retaining ring or the gasket beneath. Re-secure the ring and gasket using the
screws removed from the plate.
C. From inside the fi rebox, insert the 4" (10.2cm) fl ue pipe / gasket assembly
through the heat shield and out through the retaining ring. Secure the
assembly to the rear and top of the appliance using 4 #8 x ¾" Hex Head
Wildrill screws supplied. Do not overtighten. The gasket needs only to be snug against the fi rebox.
20
W415-1345 / D / 05.01.17