Pre-Installation Preparation; Door Operation; Rear Exit; Top Vent - Napoleon BGD36CFGN-1 Installation And Operating Instructions Manual

4.0 PRE-INSTALLATION PREPARATION

For optimum performance, it is recommended that all horizontal runs have a 1" (25mm) rise per foot.
4.1

DOOR OPERATION

Release the top and bottom door latches, located at the right side of the door.
4.2

REAR EXIT

FAILURE TO INSTALL THE CAP WILL CAUSE THE APPLIANCE TO FUNCTION IMPROPERLY AND
From inside the fi rebox, insert the 4" (102mm) fl ue pipe / gasket assembly (provided)
through the rear of the fi rebox. Secure the gasket assembly to the rear and top of the
appliance using 4 #8 x ¾ inch Hex Head Wildrill screws supplied.
Do not overtighten. The gasket needs only to be snug against the fi rebox.
Before attaching elbows to the collars on the back of the appliance, 1½" (38mm) will
need to be trimmed off the 4" (102mm) collar.
4.3

TOP VENT

FAILURE TO INSTALL THE CAP WILL CAUSE THE APPLIANCE TO FUNCTION IMPROPERLY AND
Remove the 7" (178mm) diameter cap from the top of the appliance and
A.
re-secure it over the 7" (178mm) collar located at the rear of the appliance.
Press fi rmly on the cap while securing to ensure an airtight seal. Do not
damage the gasket.
Remove the plate covering the 4" (102mm) diameter fl ue opening (seen
B.
inside the top of the 7" (178mm) diameter collar) and discard. Try not to
disturb the retaining ring or the gasket beneath. Re-secure the ring and
gasket using the screws removed from the plate.
From inside the fi rebox, insert the 4" (102mm) fl ue pipe / gasket assembly
C.
through the heat shield and out through the retaining ring. Secure the assembly to the rear and top
of the appliance using 4 #8 x ¾" Hex Head Wildrill screws supplied. Do not overtighten. The gasket
needs only to be snug against the fi rebox.
WARNING
!
CAN CAUSE INJURY OR PROPERTY DAMAGE.
WARNING
!
CAN CAUSE INJURY OR PROPERTY DAMAGE.
21
EN
W415-1361 / 11.28.14