Adding Values; Subtracting Values; Deleting The Memory; Deleting Measured Values - Bosch GLM 50 C Original Instructions Manual

If there is no value available in the memory, "0.000" is shown at the bottom of the dis-
play and "0" at the top.
The oldest value is located in position 1 in the memory, while the newest value is in
position 30 (when 30 memory values are available). When a further value is saved,
the oldest value in the memory is always deleted.

Deleting the Memory

To delete the content of the memory, press button 7 [Func] and select the memory
function . Then briefly press the On/Off button 5 [
value.
Simultaneously pressing the button 4 and the On/Off button 5 [
stored in the memory.
Adding/Subtracting Values
Measured values or end results can be added or subtracted.

Adding Values

The following example describes the addition of areas:
Measure an area as described in section "Area Measurement", see page 17.
Press the button 3 [+]. The calculated area and the symbol "+" will be
displayed.
50.039 m 2
0.0°
+93.406 m 2
Press the measuring button 2 [
Measure the area as described in section "Area Measurement", see
143.45 m
2
page 17. Once the second measurement is completed, the result of the
second area measurement is displayed below.To show the end result,
press the measurement button 2 [
Note: With a length measurement, the end result is displayed immediately.
To exit addition, press button 7 [Func].

Subtracting Values

To subtract values, press button 8 [–]. The subsequent steps are the same as for
"Adding Values".

Deleting Measured Values

Briefly pressing the On/Off button 5 [
measuring functions. Repeated brief pressing of the On/Off button 5 [
the measured values in reverse order.
Bosch Power Tools
] to delete the displayed
] to start another area measurement.
] once more.
] will delete the last measured value in all
English | 21
] deletes all values
] will delete
1 609 92A 3UB | (15.3.17)