Fujitsu DL7600 Maintenance Manual page 58

Installation
1. Connect the connector to the card edge of the print head.
2. Fit the mounting bosses of the print head into the holes on the carriage.
3. Connect the fan connector.
FAN connector
Print head
Note. Be carefully to insert the card edge straightly.
4. Fix the print head by two screws..
5. Insert the fan cables under black plastic part.
Note. If the FAN cable protrude from black plastic part.
FAN cable may be damaged by ribbon feed mechanism on left side frame.
Screws
Note: The following adjustments are required after installation:
- Bi-directional printing positions
Card edge
Connector
Figure 4.23 Print head Installation
Figure 4.24 Print head Installation
58
Bosses of Print head