Setting For Functions - JUKI SC-922 Engineer's Manual

(4) Setting for functions

Functions can be selected and specified.
(Caution) For the function setting procedure of any operation panel other than CP-18, refer to the Instruction
Manual for the operation panel to be used.
C
D
C
D
C
D
A
B
B
A
A
B
E
A
B
E
1. Turn ON the power with
pressed.
Buzzer sounds when push the switch more than
three seconds and gets possible to operate the
function setting of the service level.
(The item which has been changed during the
previous work is displayed on
When PASS appears at the display item
operation above, enter the password using the
switches
and then press the switch
No. item.
If the switch is held down for 3 sec. or more, a
buzzer sounds and function settings at the service
level can be performed.
If you forget your password, function settings
cannot be performed. In such a case, initialize the
data with reference to "13. Initialization setting
data" of Instruction Manual.
* If the screen display does not change, re-carry out
operation described in step 1.
(Caution) Be sure to re-turn ON the power switch
when one or more seconds have passed after
turning it OFF. If the power switch is re-turned
ON immediately after turning it OFF, the sewing
machine may fail to operate normally. In such
a case, be sure to turn ON the power switch
again properly.
2. To move the setting No. forward, press
. To move the setting No. backward, press
switch
(Caution) If the setting No. is moved forward (or
backward), the previous (or subsequent)
content of the setting is confirmed. Be
careful when the content of a setting is
changed (when the
touched).
Example) Changing the maximum number of
revolutions (setting No. 96)
Press
match indication department
setting No. "96."
The current set value is displayed on
indicator
Press
value to "2500."
– 17 –
switch
A
.)
and to undo the password lock
to display the setting
.
/
switch or switch
B
.
switch to change the set
held
A
at the
switch
switch is
and
A
with