Setting For Functions - JUKI SC-920 Engineer's Manual

(6) Setting of functions
Functions can be selected and specified.
(Caution) For the function setting procedure of any operation panel other than CP-18, refer to the In-
struction Manual for the operation panel to be used.
* The content of setting of the setting No. returns to the initial value by pressing
switch simultaneously.
3. After completion of the changing procedure, press
dated value.
(Caution) If the power is turned OFF before carrying out this procedure, the changed content is not up-
dated. When
No. When switch
No. After completion of the operation, the machine is returned to the normal sewing state by turn-
ing OFF the power and re-turning it ON.
switch is pressed, the display on the panel changes to the previous setting
is pressed, the display on the panel changes to the subsequent setting
1. Tu r n O N t h e p o w e r w i t h
switch
(The item which has been changed
during the previous work is dis-
played.)
* I f t h e s c r e e n d i s p l a y d o e s n o t
change, re-carry out operation de-
scribed in step 1).
(Caution) Be sure to re-turn ON the
power switch when one or more
seconds have passed after turn-
ing it OFF. If the power switch is
re-turned ON immediately after
turning it OFF, the sewing ma-
chine may fail to operate normally.
In such a case, be sure to turn ON
the power switch again properly.
2. To move the setting No. forward,
press
setting No. backward, press
switch
(Caution) If the setting No. is moved
forward (or backward), the previ-
ous (or subsequent) content of
the setting is confirmed. Be care-
ful when the content of a setting
is changed (when the
switch is touched).
Example) Changing the maximum num-
ber of revolutions (setting No. 96)
Press
to call setting No. "96."
The current set value is displayed
on indicator
Press
change the set value to "2500."
switch or
– 36 –
held pressed.
switch . To move the
.
/
switch or switch
.
switch 10 times to
switch and
switch to confirm the up-