Table of Contents
Advertisement
Figure 38. Front bezel removal
Replacing the Bezel
Use this information to install the bezel.
Before you install the bezel, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To install the bezel, complete the following steps:
Step 1.
Remove the cover (see "Removing the compute node cover" on page 113).
Step 2.
Grasp the bezel and install the bezel into the compute node.
Bezel
.
Chapter 5
Removing and replacing components
123
Advertisement
Table of Contents
Troubleshooting
