Installing The Rear Hard Disk Drive Cage - Lenovo NeXtScale nx360 M5 Installation And Service Manual

Figure 50. Removing a hard disk drive cage (1.8-inch)
Step 1. Remove the cover (see "Removing the compute node cover" on page 113).
Step 2. Remove the easy-swap hard disk drives or the solid-state drives (see "Removing and installing
drives" on page 164).
Step 3. Remove the hard disk drive backplate if there is one (see "Removing the hard disk drive backplate"
on page 160).
Step 4. Using a Phillips (for 3.5-inch hard disk drive cage) or T8 torx (part number 00FK488, for 2.5-inch or
1.8-inch hard disk drive cage, provided on the back of the chassis) screwdriver, remove the screws
(four for 3.5-inch hard disk drive cage and three for 2.5-inch or 1.8-inch hard disk drive cage) from
the cage. Then, remove the cage from the compute node at an angle.
Step 5. For cable routing, see "Internal cable routing and connectors" on page 216.
If you are instructed to return the hard disk drive cage, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Installing the rear hard disk drive cage

Use this information to install the rear hard disk drive cage.
Before you install the rear hard disk drive cage, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To install the rear hard disk drive cage, complete the following steps.
132
Lenovo NeXtScale nx360 M5 Installation and Service Guide