AEG L 82470 BI User Instructions page 24

24 www.aeg.com
Problem
The appliance does
not start:
The appliance does
not fill:
The appliance fills then
empties immediately:
The applince does not
empty and/or does not
spin:
Possible cause/Solution
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power sock-
et.
• Insert the plug into the power socket.
There is no power at the socket.
• Check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme dial is not correctly positioned and
the button 8 has not been pressed.
• Please turn the programme dial and press the but-
ton 8 again.
The delay start has been set.
• If the laundry is to be washed immediately, cancel
the delay start.
The Child safety lock has been activated.
• Deactivate this device.
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are
blocked.
• Clean the water inlet filters.
The door is not properly closed.
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Water drainage»
section in «Water drainage» chapter.
The drain hose is squashed or kinked.
• Check the drain hose connection.
The drain filter is clogged.
• Clean the drain filter.
You have set an option or a programme that ends
with the water still in the tub or a that eliminates all
the spinning phases.
• Set the draining or the spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.