ENGLISH FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
Page 4
Children between 3 and 8 years of age and persons • with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. Children of less than 3 years of age should be kept •...
ENGLISH The appliance must be connected to the water mains • using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. • If the mains power supply cable is damaged, it must •...
Page 6
2.4 Use to a grounding connection in the building. • Always use a correctly installed WARNING! shockproof socket. Risk of injury, electric shock, • Make sure that the parameters on the fire, burns or damage to the rating plate are compatible with the appliance.
ENGLISH • Concerning the lamp(s) inside this • Disconnect the appliance from the product and spare part lamps sold mains electrical and water supplies. separately: These lamps are intended • Cut off the mains electrical cable to withstand extreme physical close to the appliance and dispose of conditions in household appliances, such as temperature, vibration,...
ENGLISH Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 10 bar (1.0 MPa) Cold water Water supply Maximum Load Cotton 9 kg Spin Speed Maximum spin speed 1551 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 5.
Page 10
7. Remove the polystyrene protection 10. Remove the three bolts by using the from the bottom. spanner supplied with the appliance. 8. Pull up the appliance in vertical 11. Pull out the plastic spacers. position. 12. Put the plastic caps, that you find in the user manual bag, in the holes.
Page 11
ENGLISH 2. Position it toward left or right WARNING! depending on the position of the Do not put cardboard, wood water tap. or equivalent materials below the appliance feet to adjust the level. 45º 45º 20º 20º Make sure that the inlet hose is not in vertical position.
Page 12
The red sector in the window «A» shows this fault. If this occurs, close the water tap and Make sure that the drain contact the authorized service centre to hose end is not immersed in replace the hose. the water. There may be a 5.5 Water drainage...
Page 13
ENGLISH 5. Without the plastic hose guide, to The rating plate and the 'Technical Data' a sink spigot - Put the drain hose in chapter indicate the necessary electrical the spigot and tighten it with a clamp. ratings. Make sure that they are Refer to the illustration.
6. CONTROL PANEL 6.1 Control panel description 11 10 The options are not selectable with all washing programmes. Check the compatibility between options and washing programmes in the "AutoDose and options compatibility with programmes" paragraph in the "Programmes" chapter. An option can exclude another one, in this case the appliance doesn't allow you to set the incompatible options together.
Page 15
ENGLISH By touching this button you can set: • Rinse Only at first touch. The washing programme starts from the rinsing phase by skipping the washing phase. All set options (except permanent extra rinse) are deselected automatically. Option - Skip‐ •...
Page 16
Press this button repeatedly to activate one of the two options or both. The relevant indicator comes on in the display. • Remote Select this option to connect appliance with App. Touch this button, the display shows the indicator blink‐...
Page 17
ENGLISH Press this button repeatedly to activate one of the two options or both. The relevant indicator comes on in the display. • Intensive By setting this option, the indicator appears close to deter‐ gent symbol, and the machine will automatically dose an extra amount of detergent when automatic detergent tank is ena‐...
Page 18
When you set a programme, the appliance automatically selects the maximum spin speed. Touch this button repeatedly to: • Decrease the spin speed. The display shows only the spin speeds avail‐ able for the set programme. • Activate the Rinse Hold option .
Page 19
ENGLISH With this option you can permanently have an extra rinse. To activate/deactivate this option touch the Spin button and the Intensive/Prewash button simultaneously, the relevant indicator Permanent Extra Rinse comes on/goes off over rinse phase symbol. This option adds two rinses. With this option you can prevent that the children play with the control panel.
Page 20
Wi-Fi connection indicator. Remote connection indicator. Delay start indicator. Door locked indicator. The digital indicator can show: • Maximum load indicator: e.g. Cottons . The icon flashes dur‐ ing laundry load estimation. Refer to "ProSense load detection" para‐ graph.
ENGLISH Extra Silent indicator. Prewash indicator. Intensive indicator. AutoDose liquid detergent tank indicator. When it lights, appliance auto‐ matically doses the detergent. This indicator appears beside when Intensive option is set. AutoDose softener tank indicator. When it lights, appliance automatically doses the softener.
5. Set and start a programme for cotton This removes all possible dirt from the at the highest temperature without drum and the tub. any laundry in the drum. 8. THE AUTODOSE TECHNOLOGY (AUTODOSING) Read this chapter carefully. In some programmes,...
Page 23
ENGLISH • Maximum level for detergent/ AutoDose additives quantity. 8.3 AutoDose basic setting Manual The factory pre-set doses for a large load are 90 ml for detergent tank and 25 ml for fabric softener tank: the optimal configuration to meet majority of use condition.
Page 24
Water hardness levels Levels Water hardness range mmol/l °f °d °e Soft <15 <8 <10 <1.4 <140 15 - 25 8 - 14 0 - 17 1.5 - 2.5 150 - 250 Medium Hard >25 >14 >17 >2.5 >250...
Page 25
ENGLISH 8.5 Filling the detergent and additives on AutoDose system Please read "Detergents and other treatments" in "Hints and tips" chapter. We recommend that you do not exceed the maximum indicated level ( 4. Gently pour only liquid softener in the 1.
Page 26
8.7 Switching from AutoDose to manual dosing It is possible to disable AutoDose function for one or both tanks by pressing related button symbol. Example: • To switch Fabric Softener tank off, press the button until the display shows OFF.
Page 27
ENGLISH 2. After about 10 seconds the display returns to the programme information screen. 3. If desired, pour the fabric softener in 8.9 Manual filling the detergent and additives the compartment Manual You may need to use a different detergent or fabric softener than the ones used in the AutoDose tanks.
8.10 Drawer open indication When a programme is running, the detergent drawer must always be closed. A sensor in the drawer detects if the drawer is open (or not properly closed) while the programme is running. In such case, the appliance will immediately be paused.
Page 29
ENGLISH Programme Programme description White cotton and coloured cotton. Normally, heavily and lightly soiled items. Cottons Cotton and fast-coloured synthetic items. Complete wash‐ ing programme that, in only 59 minutes, washes the daily OKOPower soiled laundry intensively and ensures a good washing per‐ formance in a short time.
Page 30
Programme Programme description Do not use fabric softener and make sure that Outdoor there is no softener residue in the detergent dispenser. Outdoor clothing, technical, sport fabrics, waterproof and breathable jackets, shell jackets with a removable fleece or inner insulation. The recommended laundry load is 2.5 kg.
Page 31
ENGLISH Programme Default tempera‐ Reference spin Maximum load ture speed Temperature Spin speed range range 40 °C 1200 rpm 4 kg 60 °C - Cold 1200 rpm - 400 rpm Synthetics 30 °C 800 rpm 2 kg 40 °C - Cold 1200 rpm - 400 rpm Delicates 40 °C...
Page 33
ENGLISH ■ ■ ■ ■ Plus Steam 1) This option is not available with temperature lower than 40 °C. 2) If you set the shortest duration, we recommend that you decrease the load size. It is possible to fully load the appliance, however the washing results can be less satisfactory. 3) This option is not available with temperature lower than 40 °C.
This chapter describes how to connect the smart appliance to the Wi-Fi network configuring "My AEG" and to link it to mobile devices. "My AEG" allows you to By this functionality you can receive control your laundry through notifications, control and monitor your a mobile device.
Page 35
Start/Pause button to start the 4. Configure the "My AEG" app on your programme, but it is also smart device and follow the possible to start a washing instructions to connect the appliance programme remotely.
When the App is installed and the To remove the Remote Start, tap on the wireless connection is complete, you can Remote button and confirm by activate the Remote Start: pressing the Start/Pause button. 1. Touch the Remote button and the 10.4 Over-the-air update...
Page 37
ENGLISH related programme indicator comes The indicator of the Start/Pause button flashes. The display shows an indicative programme duration, the maximum declared load for the set programme (only for a few seconds), the default temperature, the default spin speed and the washing phase indicators (when available).
Page 38
When the countdown is completed, the programme duration could increase programme starts. or decrease. At the end of the load detection, if The ProSense estimation laundry load is below the maximum starts at the end of the declared weight for selected countdown.
Page 39
ENGLISH E.g. the washing or pre wash phase is If the ProSense phase is already carried out and the water filling is already running: started, the new programme When the phase ends the relevant starts without repeating the indicator stops flashing and is steady on. ProSense phase.
In the display all washing phase 1. If necessary, touch the Spin button to indicators become steady and the time decrease the spin speed proposed by the appliance. area shows . 2. Touch the Start/Pause button: The indicator of the Start/Pause button •...
Page 41
ENGLISH 12.1 The laundry load • Divide the laundry into: white, coloured, synthetics, delicates and wool. • Follow the washing instructions on the laundry care labels. • Do not wash white and coloured items together. • Some coloured items can discolour with the first wash.
• The choice and quantity of detergent save detergent, water and time (the will depend on: type of fabric environment is protected too!). (delicates, woollens, cottons, etc), the • Loading the appliance to the colour of clothes, size of the load,...
Page 43
ENGLISH 13.4 Descaling Clean drum Every two months If the water hardness in your Clean detergent dis‐ Twice a year area is high or moderate, we recommend that you use a penser and Auto‐ water descaling product for Dose tanks washing machines.
Page 44
Occasionally, at the end of a cycle the display may show the icon : this is a recommendation to perform the “drum cleaning”. Once the drum cleaning has been performed, the icon disappears. 13.8 Cleaning the detergent Clean it when needed, using ammonia...
Page 45
ENGLISH 5. Wash the drawer and all inserts under running water. 3. Open the drain plugs of each tank and empty them into a sink. CAUTION! Do not use sharp or metal brushes and sponges. 6. Turn the dispenser up side down and open the bottom cover as indicated in the picture.
Page 46
WARNING! If some residues remain on the back area of tanks, soak detergent drawer in a warm CAUTION! water. Do not use tools to Press the bottom cover as clean it. Before soaking, indicated in the picture. remove the handle by...
Page 47
ENGLISH 13.9 Cleaning the drain pump b. Place the bottom cover and press till "click" sound. c. Place the top cover on the tanks WARNING! compartment and press till "click" Disconnect the mains plug sound. from the mains socket. d. Replace components on manual compartment.
Page 48
Authorised Service Centre. 4. Turn the filter 180 degrees in anti- clockwise direction to open it, without removing. Let the water flow out. 10. Clean the filter under the water tap. 11. Put the filter back into the special guides by turning it clockwise.
Page 49
ENGLISH When you drain the water with the 3. Clean the valve filter on the back of emergency drain procedure, you must the appliance with a toothbrush. activate the drain system again: a. Put 2 litres of water in the main wash compartment of the detergent dispenser.
1. Put 2 litres of water in the main wash 3. Put the two ends of the inlet hose in compartment of the detergent a container and let the water flow out dispenser. of the hose. 2. Start the programme to drain the 4.
Page 51
ENGLISH • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. The appliance does • Make sure that the drain filter is not clogged. Clean the filter, if not drain the water.
Page 52
Problem Possible solution The appliance fills with • Make sure that the drain hose is in the correct position. The water and drains im‐ hose may be positioned too low. Refer to "Installation instruc‐ mediately. tion". • Set the spin programme. If the drain programme is not availa‐...
Page 53
ENGLISH Problem Possible solution • Make sure that the wireless signal reaches the appliance. Try to move the home router as near the appliance as possible or The App cannot fre‐ consider purchasing a wireless range extender. quently connect to the •...
Page 54
Problem Possible solution After the washing cy‐ • Make sure that the flap is in the correct position (UP for pow‐ cle, there are some der detergent - DOWN for liquid detergent). detergent residues in • Make sure you have used the detergent dispenser according the dispenser drawer.
ENGLISH 15. CONSUMPTION VALUES 15.1 Introduction See the web link www.theenergylabel.eu for detailed information about Energy Label. The QR code on the energy label supplied with the appliance provides a web link to the information related to the performance of the appliance in the EU EPREL database.
Page 56
Eco 40-60 pro‐ Litres h:mm °C gramme Quarter load 0.178 2:25 1551 1) Maximum spin speed. Power consumption in different modes Delay start Networked Off (W) Stand-by (W) standby (W) 0.50 0.50 4.00 2.00 Time to Off/Standby mode is 15 minutes maximum.
16.2 Fixing plate kit If you install the appliance on a plinth that is not an accessory supplied by AEG, secure the appliance in the fixing plates. Read carefully the instructions supplied with the accessory. 16.3 Stacking kit...
Page 60
My AEG Care app The software in this product contains components that are based on free and open source software. AEG gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://aeg.opensoftwarerepository.com (folder NIU5)