15
COOLING SYSTEM
(TC 125)
–
Make sure that screw
–
Position the motorcycle upright.
–
Completely fill the radiator with coolant.
Coolant (
M01337-10
–
Loosen screw
–
Mount and tighten screw
Guideline
Bleeder screw, cylinder head
–
Completely fill the radiator with coolant.
Coolant (
M01338-10
–
Mount radiator cap
S01287-10
–
Allow the engine to warm up and cool down again.
–
Check the cooling system for leaks.
–
Check the coolant level. (
(TC 250, TX 300)
–
Make sure that screw
–
Position the motorcycle upright.
–
Completely fill the radiator with coolant.
Coolant (
S01288-10
–
Loosen screw
–
Mount and tighten screw
Guideline
Bleeder screw, cylinder head
(TC 250)
Bleeder screw, cylinder head
(TX 300)
–
Completely fill the radiator with coolant.
S01289-10
Coolant (
is tightened.
p. 128)
until coolant escapes without bubbles.
.
p. 128)
.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when running the
engine.
–
Use an effective exhaust extraction system when starting or run-
ning the engine in an enclosed space.
p. 92)
is tightened.
p. 128)
until coolant escapes without bubbles.
.
p. 128)
M6
8 Nm (5.9 lbf ft)
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
94