Husqvarna TC 125 2017 Owner's Manual page 73

11 SERVICE WORK ON THE CHASSIS
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
H01558-10
(TC 125)
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 (
–
Remove bleeder screw
–
Mount bleeding syringe
F00252-10
(TC 250, TX 300)
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 (
–
Remove bleeder screw
–
Mount bleeding syringe
F00253-10
–
Now inject the liquid into the system until it emerges from drill hole
master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
H01559-10
Info
Clean up overflowed or spilled brake fluid immediately with water.

.
 
with membrane .

with the appropriate hydraulic fluid.
p. 128)

.

on the clutch slave cylinder.

with the appropriate hydraulic fluid.
p. 128)

.

on the clutch slave cylinder.

4 mm (0.16 in)
71
of the