Husqvarna TC 125 2017 Owner's Manual page 108

17 SERVICE WORK ON THE ENGINE
Main work
(TC 125)
–
Remove the gear oil drain plug with magnet
–
Remove gear oil drain plug
–
Remove filler plug
–
Let the gear oil drain fully.
–
Clean the gear oil drain plug thoroughly.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug with the magnet
ring.
Guideline
Gear oil drain plug with magnet
–
Mount gear oil drain plug
Guideline
Gear oil drain plug
S01278-10
–
Fill in gear oil.
Gear oil
–
Mount and tighten filler plug
–
Start the engine and check that it is oil-tight.
(TC 250, TX 300)
–
Remove the gear oil drain plug with magnet
–
Remove filler plug
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug with the magnet
ring.
Guideline
Gear oil drain plug with magnet
(TC 250)
Gear oil drain plug with magnet
(TX 300)
–
Fill in gear oil.
Gear oil
–
Mount and tighten filler plug
S01277-10

.

.

with the new seal ring and tighten.
0.8 l (0.8 qt.)

.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when running the
engine.
–
Use an effective exhaust extraction system when starting or run-
ning the engine in an enclosed space.

.
0.8 l (0.8 qt.)

.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when running the
engine.
–
Use an effective exhaust extraction system when starting or run-
ning the engine in an enclosed space.

.

and the new seal
M12x1.5 20 Nm
(14.8 lbf ft)
M10x1 15 Nm
(11.1 lbf ft)
Engine oil (SAE 10W/40) (

.

and the new seal
M12x1.5 20 Nm
(14.8 lbf ft)
M12x1.5 20 Nm
(14.8 lbf ft)
Engine oil (SAE 10W/40) (
106
p. 128)
p. 128)