Network Setup - Oki c332 User Manual

N S
ETWORK ETUP
This menu controls the operation of the printer's network interface.
ITEM
ENABLING DEFAULT
GATEWAY
WIRED
TCP/IP
NETBIOS OVER TCP
IP ADDRESS SET
IPV4 ADDRESS
SUBNET MASK
GATEWAY ADDRESS
WEB
TELNET
FTP
IPSEC
SNMP
NETWORK SCALE
GIGABIT NETWORK
SETTINGS
WIRED
WIRELESS
(INFRASTRUCTURE)
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
AUTO
MANUAL
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
NORMAL
SMALL
ENABLE
DISABLE
Operator panel > 35
EXPLANATION
Enables or disables this network protocol.
Sets Enable/Disable of NetBIOS over TCP protocol.
Display Conditions: TCP/IP should be enabled.
Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.
Current assigned IP address. To change, press OK and
use Menu buttons to increment 1st octet, then press
OK again to move on to next octet. When 4th octet has
been set, press OK again to register new address.
Current assigned subnet mask. To change, proceed as
above.
Current assigned gateway address. To change, proceed
as above.
Enables or disables Web config. facility.
Enables or disables Telnet config. facility.
Enables or disables communication via FTP.
Sets Enable/Disable of IPSec. Enable via the web.
Enable: IPSec is available.
Disable: IPSec is not available.
Enables or disables SNMP protocol.
Selects network size.
When NORMAL is selected, printer can work effectively,
even when connected to a HUB that has a spanning
tree feature. However, printer start up time gets longer
when computers are connected with two or three small
LANs.
When SMALL is selected, computers can cover from two
or three small LANs to a large LAN, but may not work
effectively when connected to a HUB that has a
spanning tree feature.
Sets whether to enable access with Gigabit Ethernet.