Panel Setup; Power Setup; Tray Setup - Oki c332 User Manual

P S
ANEL ETUP
ITEM
NEARLIFE STATUS
NEARLIFE LED
P S
OWER ETUP
ITEM
AUTO PW OFF
POWER RETURN
T S
RAY ETUP
ITEM
UNIT OF MEASURE
DEFAULT PAPERSIZE
SETTINGS EXPLANATION
ENABLE Set LCD panel control at the time of near-life
warning for drum.
DISABLE
Enable: Display a near-life warning.
Disable: Do not display a near-life warning.
ENABLE Enables/disables illumination of front panel LED
when "near-end-of-life" warning of a toner or
DISABLE
drumoccurs.
Attention LED is lit when setting is enabled,
inhibited when disabled.
SETTINGS EXPLANATION
ENABLE Sets the Auto Power Off operation.
AUTO CONFIG ENABLE: When the printer is not used for a
period of time, it turns off the power
DISABLE
automatically.
AUTO CONFIG: Auto power off is enabled,
however, the printer will not turn off the power
under the following conditions:
> An Ethernet cable is plugged to the network
interface connection.
Note: The default setting varies depending on the
sales area.
MANUAL Set the power on method after energize.
STATE
CONTINUE
SETTINGS EXPLANATION
INCH Selects the unit of measure.
MILLIMETER Note: The default setting varies depending on the
sales area.
A4 Set default paper size.
LETTER Note: The default setting varies depending on the
sales area.
Operator panel > 45