1206 - Initialize Dci - NEC 28i System Manual

1206 - Initialize DCI

Description
After changing the register values in Program 1201, use Program
1206 - Initialize DCI to initialize the PMS DCI software port. You
must initialize the PMS DCI software port before the changes you
made in Program 1201 will take effect. You may also have to initial-
ize the PMS DCI software port if the cable connecting the phone sys-
tem to the PMS system is temporarily unplugged.
After programming the PMS options and starting the PMS
system, you must use Program 1206 to initialize the PMS
DCI port. Optionally, you can dial Service Code 880 at the
DCI telephone to initialize the PMS DCI port.
Conditions
None
Default Setting
None
Feature Cross Reference
PMS Integration
Telephone Programming Instructions
To enter data for Program 1206 (Initialize DCI):
1. Enter the programming mode.
2. 1206 + HOLD.
DCI No?
3. Enter the DCI software port you want to program + HOLD.
DCI Module software ports are 1-144. 3-DCI software ports
are 145-288.
DCI_nnn Initial!:
This indicates that the DCI software port selected has been
successfully initialized.
4. HOLD
DCI No?
5. Repeat from step 3 to initialize another DCI software port.
OR
HOLD to exit.
3-34
Important