Appendix C: Reo Quick Install Guide; Introduction; Required Software Version; Installation - Philips DVR1EP08 Installation Instructions Manual

1.1

Introduction

This guide provides the steps necessary to install the DVR1 in combination with a REO Multiplexer or REO Switcher Monitor. If you
are not familiar with the operations of the DVR1 and the REO Monitor, refer to the corresponding instruction manuals.
1.2

Required Software Version

Ensure that the DVR1 and REO monitor's software version is equal to or higher than noted below.
Product
DVR1 (all models)
REO Multiplexer Monitor
REO Switcher Monitor
1.3

Installation

1.3.1 Connection of Audio/Video Cable (A/V Cable)

To record camera images, the REO VCR In/Output allows connection of the DVR1. Connect the Mini Din plug to the VCR
connector of the REO System Monitor.
1. Connect the BNC connectors to the VIDEO IN and VIDEO OUT of the DVR1.
ATTENTION:
VIDEO IN of the A/V cable must be connected to VIDEO OUT of the DVR1.
VIDEO OUT of the A/V cable must be connected to VIDEO IN of the DVR1.
2. Connect the black VEXT cable (located in the A/V cable) to the VEXT-pulse output of the DVR1 (Pin 5 of Accessories port) for
proper synchronization between the System Monitor and DVR1.
3. If the DVR1 also has audio recording capabilities, connect the RCA connectors to AUDIO IN and AUDIO OUT of the DVR1.
ATTENTION:
AUDIO IN of the A/V cable must be connected to AUDIO OUT of the DVR1.
AUDIO OUT of the A/V cable must be connected to AUDIO IN of the DVR1.

1.3.2 Connection of Alarm Contact

In case of an alarm, the output relay contact of the REO System Monitor can change the recording speed from Normal recording to
Alarm recording until the alarm is acknowledged by the user or automatically resets after the programmed alarm time has expired.
Alarm Relay
1 2 3 4
Alarm IN
VEXT

APPENDIX C: REO QUICK INSTALL GUIDE

Software Version
1.14 or higher (available at www.philipscsi.com)
2.01c or higher
1.00 or higher
Camera 1–8
To Slave Monitor
Connect
Accessories
PCB to
Accessories
Port of DVR1
1 6
2 7
3 8
4 9
GND
5
GND
VCR (Playback Only)
VIDEO OUT
VIDEO
IN
AUDIO AUDIO OUT
IN
TV/Monitor
Not Used
VIDEO IN
VIDEO
OUT
AUDIO IN
AUDIO
OUT
Time-lapse VCR
VIDEO OUT
VIDEO
IN
VIDEO IN
VIDEO
OUT
VEXT
AUDIO AUDIO OUT
IN
AUDIO AUDIO IN
OUT
33
VIDEO
To VIDEO OUT of DVR1
IN
VIDEO
To VIDEO IN of DVR1
OUT
To Pin 5 of Accessories
PCB of DVR1 (VEXT)*
AUDIO
To AUDIO OUT of DVR1
IN
AUDIO
To AUDIO IN of DVR1
OUT
*Not required by REO Switcher