Table of Contents
Advertisement
5.11 Restoring Factory Defaults
Advanced Menu ➝ Factory Settings
Use this menu to restore the DVR1 to the factory defaults.
NOTE: When the factory settings are restored, all programmed
settings and volume partitions for archive retrieval are erased.
The factory password is fixed at 0000. Therefore, you can
repeatedly press ENTER, and press ENTER to complete entry
and restore the unit to its factory default settings.
5.12 Changing the Password
Advanced Menu ➝ Change Password
Use this menu to change the Advanced Menu Password. It is
recommended that the System Administrator change this
password to prevent unauthorized access to the menu.
Use the Up/Down Arrows to select a character, then press ENTER
and move to the next character.
Pressing ENTER on the last character opens the Confirmation Box.
Reenter the New password.
Pressing ENTER on the last character completes the password
selection.
If the password in the Confirmation Box matches the
password from the Password Box, the message at right will
appear.
Press ENTER to select [OK] and exit the menu.
If the password in the Confirmation Box does not match the
password from the Password Box, the message at right will
appear.
Press ENTER to select [OK] and exit the menu.
PASSWORD BOX
PLEASE ENTER THE FACTORY PASSWORD
PASSWORD BOX
ENTER A NEW PASSWORD
CONFIRMATION BOX
PLEASE RE-ENTER THE PASSWORD
MESSAGE
THE NEW PASSWORD HAS BEEN ACCEPTED
THE PASSWORD WAS NOT CHANGED!
23
O
– – –
O
– – –
O
– – –
[OK]
MESSAGE
[OK]
Advertisement
Table of Contents
