Philips DVDR 75 Owner's Manual page 35

During installation, all available TV channels are searched for and saved. If the channel
assignments of your cable or satellite TV provider change or if you are reinstalling the DVD
recorder, e.g. after moving, you can start this procedure again. This will replace the TV channels
already saved with the new ones.
1
Turn on your TV. Select the channel number for the DVD
Recorder (channel 3 or 4 or the Audio/Video In channel).
2
Turn on the DVD Recorder by pressing STANDBY/ON m .
3
Press SYSTEM-MENU on the remote control. The menu bar
will appear at the top of the TV screen.
4
' using D or C .
Select '
5
Press CH- B continuously to select the line '
on the second screen of menus.) Confirm with C .
6
Select line '
CH+ A .
7
Press C . The automatic TV channel search starts. This allows
the DVD Recorder to save all available TV channels. This
procedure may take several minutes.
8
When the channel search is completed, '
' will appear on the TV screen.
9
Press SYSTEM-MENU repeatedly to remove all the menus
from the screen.
a
b During 'Automatic channel search' the DVD Recorder detects
whether an antenna or a cable TV signal is connected. If you have
connected a cable TV signal but found very few TV channels, you
must search the channels manually.
To do so, select '
1
If you select '
2
If you select '
Select your type of connection by pressing C repeatedly:
' ', '
have.
Confirm the setting with OK .
3
Press SYSTEM-MENU to go to the next menu. Press OK to
4
start channel search as prompted by the on-screen message. When
the channel search is complete, press SYSTEM-MENU repeatedly
to remove all the menus.
Installing your DVD recorder
' using
' instead of line '
' in step 6 and confirm with C .
', channels 1-125 will be available.
', channels 2-69 will be available.
' or ' automatically detects which one you
'. (It is
CH- B or