Table of Contents
Advertisement
Available languages
Available languages
PROBLEM
SOLUTION
b
While a programmed recording is being made, you cannot operate your DVD Recorder
manually. If you want to cancel the programmed recording, press STANDBY m .
b
The DVD Recorder was switched on a few minutes before the start of a programmed
recording.
Turn off the DVD Recorder by pressing STANDBY m . A programmed recording (timer)
will only function if the DVD Recorder is switched off (button STANDBY m ).
b
Either no disc was inserted or a disc was inserted that cannot be used for recordings. Insert a
disc that can be recorded upon.
Locate on the disc the right position for the recording.
Turn off the DVD Recorder by pressing STANDBY m .
b
A protected disc was inserted. Undo the erase protection (chapter 'Manual recording', section
'Preventing accidental erasing of discs '), or insert a different disc.
b
If this error message appears after pressing TIMER , then all TIMER blocks are already
programmed. No more recordings can be programmed. Press the C button. Select the
programmed recording (TIMER block) you want to check or clear using CH+ A or CH- B .
b
The data for the recording could not be transferred. Please check date, start time, and end
time of the programmed recording.
b
The timer recording overlaps with another timer recording.
b
If you ignore this warning, the programmed recording with the early start time will start first.
The second recording will then lack the beginning.
b
Change the information for one of the two recordings.
b
Delete one of the two recordings.
Programming a recording (TIMER)
Advertisement
Table of Contents
