Table of Contents
Advertisement
Available languages
Available languages
7
Select the desired screen format with CH- B or CH+ A . This
setting only functions if you have inserted a DVD recorded in this
format.
'
' for a wide-screen display (theatrical format) with black
'
' for a full-height picture with the sides trimmed to fill you
'
' for wide-screen TV (16:9) aspect ratio
8
Confirm with OK .
9
After you connect the antenna (or cable TV, satellite receiver,
etc.) to the DVD recorder, press OK .
Make sure the cable TV signal is connected securely to the
Antenna jack on the rear of the DVD Recorder.
The automatic TV channel search starts. '
display.
a
b Select another channel on the TV. Do you see that channel on the TV
screen?
If not, check the cable connection of the antenna (antenna jack)
between the DVD Recorder and TV.
b Please have patience.
The DVD Recorder searches the entire frequency range in order to
find and save the largest possible number of TV channels.
b If no antenna is connected, complete the basic settings and then, if
desired, start the automatic channel search (see section 'Automatic TV
channel search').
a
b It is possible that the automatic switching between antenna/cable does
not properly detect your TV signal. Read the section about how to
switch manually.
10
Wait until all available TV channels have been found. This can
take several minutes.
11
As soon as the automatic TV channel search is completed, '
the number of channels found.
12
To remove the menus, press the SYSTEM-MENU button on
the Recorder's remote control.
The initial installation is now complete.
Installing your DVD recorder
bars at the top and bottom of the picture.
TV screen.
' will appear on the TV screen along with
' will appear on the
h
Advertisement
Table of Contents
