Setting The Clock; Auto Clock Setting - Magnavox 1VMN29896 Owner's Manual

Auto Clock Setting

This unit can set the time and date automatically by referring to a channel that carries a clock information. If a PBS
(public broadcasting station) is available on Cable in your area, follow "Auto Clock Setting" below. If not, follow
"Manual Clock Setting" on page 34.
Make sure
• The cable TV connections are correct.
• Channels are set. (Refer to page 29.)
32 EN EN

SETTING THE CLOCK

Analog Auto Clock Setting (Cable TV only)
Press [MENU] and use [K / L] to select
1
"General Setting", then press [OK].
"General Setting" menu will appear.
Use [K / L] to select "Clock", then
2
press [OK].
"Clock" menu will appear.
Use [K / L] to select "Auto Clock
3
Setting", then press [OK].
Use [K / L] to select "Auto", then
4
press [OK].
Auto Clock Setting
OFF
Auto
Manual
5
Press [MENU] to exit.
Press [STANDBY/ON y y ] to turn the
6
unit to the standby mode.
This unit will search for the time only when the
power is in the standby mode. Initially leave it in
standby mode for at least 15 minutes to give this
unit time to set the clock. Once the clock is set, the
unit receives the clock data at 12:00 am & 12:00 pm
when unit is in standby mode. Check the time after
the Auto Clock was set, if it is incorrect time then set
the "Auto Clock Setting" to "OFF" in step 4 above.
Then try "Manual Clock Setting" on page 34.
Note
• The clock may set itself automatically after you
connect the antenna/cable signal and plug in the
power cord.
• Only the Analog PBS channel Cable TV signal is
effective for auto clock setting.
• For analog auto clock setting, incorrect time may be
obtained depending on the broadcast information. If
this occurs, set the "Auto Clock Setting" to "OFF" at
step 4 above and try "Manual Clock Setting" on page
34.