Configuration Procedure; Table 3-2 Configuration Procedure - Honeywell DR4500A Product Manual

Configuration

Configuration Procedure

3.5 Configuration Procedure
Introduction

Each of the Set Up groups and their functions are preconfigured at the factory.

The factory settings are shown in the Set Up group tables that follow this procedure.

If you want to change any of these selections or values, follow the procedure in Table 3-2. This
procedure tells you the keys to press to get to any Set Up group and any associated Function parameter
prompt.
If you need a detailed explanation of any prompt, refer to Section 4 – Configuration Parameter

Definitions.
Procedure
Follow the procedure listed in Table 3-2 to access the Set Up groups and Function prompts.
TIP
The prompting scrolls at a rate of 2/3 seconds when the SET UP or FUNC key is held in. Also,
[▲] [▼] keys will move group prompts forward or backward at a rate twice as fast.
Step Operation
1
Select Set Up mode
2
Select any Set Up group
3
Select a Function
parameter
4
Select other Function
parameters
60 DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual

Table 3-2 Configuration procedure

Press
SET Upper Display: SET UP—Lets you know you are in the
UP configuration mode and a Set Up group title is being
displayed in the lower display.
Lower Display: INPUT 1—This is the first Set Up group
title.

SET Successive presses of the SET UP key will
UP
sequentially display the other Set Up group titles
shown in the prompt hierarchy in Figure 3-1.
 You can also use the [▲] [▼] keys to scan the Set Up
groups in both directions.

Stop at the Set Up group title which describes the
group of parameters you want to configure. Then
proceed to the next step.
FUNC
Upper Display: Shows the current value or selection for
the first function prompt of the particular Set Up group
that you have selected (EXAMPLE: ENABLE/DISABLE).
Lower Display:—Depends on what is selected in Set Up
group. Shows the first function prompt within that Set Up
group (EXAMPLE: INPUT 1).

FUNC Successive presses of the FUNC key will sequentially
display the other function prompts of the Set Up group
you have selected.

Stop at the function prompt that you want to change,
then proceed to the next step.
Result
Release M
April 2017