Configuration Tips; Table 3-1 Configuration Tips - Honeywell DR4500A Product Manual

3.4 Configuration Tips

Introduction
Listed below in Table 3-1 are some tips that will help you enter the configuration data more quickly.
Function
Displaying groups
Displaying
functions
Scrolling
Changing values
quickly
Restoring to the
original value
Exiting Set Up mode
Timing out from Set
Up mode
Key error
Release M DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual
April 2017

Table 3-1 Configuration tips

Use the SET UP key to display the Set Up groups. The group titles are listed in
this section in the order that they appear in the recorder.
Use the FUNC key to display the individual parameters under each group. The
prompts are listed in the order of their appearance in each group.
To get to a Set Up group prompt more quickly, hold the SET UP key in. To get
to a function prompt more quickly, hold the FUNC key in. The display will scroll
through the parameters.
ATTENTION
The prompting scrolls at a rate of 2/3 seconds when the SET
UP or FUNC key is held in. Also, [▲] [▼] keys will move group prompts
forward or backward at a rate twice as fast.
When Changing the value of a parameter, you can adjust a more significant
digit in the upper display by holding in one key [▲] or [▼] , and pressing the
other [▲] or [▼] at the same time.

The adjustment will move one digit to the left.

Press the key again and you will move one more digit to the left.
When you change the value or selection of a parameter while in Set Up mode
and decide not to enter it, press RUN/HOLD once, the original value or
selection will be recalled.
To exit Set Up mode, press the LOWR DISP key. This returns the display to
the same state it was in immediately preceding entry into the Set Up mode.
If you are in Set Up mode and do not press any keys for one minute, the
recorder will time out and revert to the mode and display that was being used
prior to entry into Set Up mode.
When a key is pressed and the prompt "KEY ERROR" appears in the lower
display, it will be for one of the following reasons:

parameter not available

not in Set Up mode, press SET UP key first

key malfunction, do keyboard test (operation)

individual key locked out
Tip
Configuration
Configuration Tips
59