Table 2-3 Mounting Flush In A New Panel Cutout; Figure 2-5 Mounting Flush In A New Panel Cutout - Honeywell DR4500A Product Manual

Installation - Mounting Methods
Mounting flush in panel (New panel cutout)
Refer to Figure 2-5 and follow the procedure in Table 2-3 to make a new cutout in a panel and mount your
recorder in the cutout.
Step
1
At the appropriate location, make a square cutout in the panel measuring 12.7 ±0.060 inches
by 12.7 ±0.060 inches (322.58 ±1.52 by 322.58 ±1.52 millimeters). See Figure 2-3.
2
Orient the recorder case properly and slide it into the cutout from the front of the panel.
Support the recorder as shown in steps 3 and 4.
3
Refer to Figure 2-5. From the back of the panel, attach a mounting bracket to each side of the
recorder case using a 1/4-20 x 1/2 inch hex screw and a lockwasher for each bracket
(mounting hardware supplied with recorder). Leave the screws slightly loose so you can adjust
the brackets.
4
While holding the recorder firmly against the panel, slide each bracket against the back of the
panel and tighten the screws.
18 DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual

Table 2-3 Mounting flush in a new panel cutout

Hex screw,
1/4-20 x
1/2 inch and
washer

Figure 2-5 Mounting Flush in a New Panel Cutout

Action
2 1 4 0 6
Release M
April 2017