Installation In 3Rd Party Racks - Fujitsu PRIMERGY TX200 S5 Operating Manual

Installing the hardware
4.3.3

Installation in 3rd party racks

I
The support systems from Fujitsu Technology Solutions are suitable for
use in any 3rd party racks for standard servers (installation depth 714 -
785 mm) without restrictions.
Ê Refer to the manual from the rack manufacturer for details of the mechanical
installation and the climatic conditions.
V
CAUTION!
When installing in 3rd party racks, it must be ensured that an air flow
from the front to the back of the rack is guaranteed.
Ê Fit the required original parts (support bracket or cable management
system).
I
Under certain circumstances, you will not be able to use some of the
parts from the rack installation kit supplied - you will need to use
original 3rd party rack parts instead.
Racks with installation depth of 735 mm
The lengths of the telescopic rails do not need to be adjusted with respect to
each other for the installation in rack systems with 735 mm installation depth.
Ê Secure the support systems as described in section
systems" on page
Ê Mount the server (see
cables as described in the original manual of the rack..
V
CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted (see
TX200 S5
48.
"Inserting the server" on page
figure 5 on page
Operating Manual
Installing/removing the rack model
"Installing the support
50) and route the
48).
51