Num Lock After Boot; Memory Test; Configuration Table; Boot From Landesk Service Agent - Acer M11E User Manual

2.7.5

Num Lock After Boot

This parameter allows you to activate the Num Lock function upon
booting. The default setting is
2.7.6

Memory Test

Enabled
When set to , this parameter allows the system to perform a
RAM test during the POST routine.
system detects only the memory size and bypasses the test routine.
The default setting is Enabled.
2.7.7

Configuration Table

This parameter allows you to enable or disable the appearance of the
configuration table after POST but before booting. The configuration
table gives a summary of the hardware devices and settings that BIOS
detected during POST.
2.7.8

Boot from LANDesk Service Agent

When set to Enabled , the system boots from a LANDesk Service
Agent network instead of your desktop system. The LANDesk Service
Agent is IEEE-standards-based code that intervenes in the boot
process. Please refer to your LANDesk Manual for more information.
When set to Disabled
the Boot Sequence parameter.
2-26
Enabled .
When set to
, the system boots from the drive specified in
Disabled , the
User's Guide