Sharp sh906i Before Using page 28

When a FOMA card is replaced with a new card, the terminal
security code (four to eight digits) must be entered after turning on
the terminal. If a correct terminal security code is entered,
stand-by display appears. When a wrong terminal security code is
entered five times, the power is turned off. However, turning on the
power again is possible.
When A appears, the handset is outside the service area or in a
place with no signal. Move to a place where the icon disappears.
Turning the power off
1
Press H (for 2+ seconds).
It may take some time for the power to be turned off (The end
screen appears on the display until the power is turned off).
Select language
Switching the display to English
1
In the Custom menu, select [Settings]/[一般設
定]/[Bilingual]/[English].
To switch the display language from English to Japanese: In the
Custom menu, select [Settings]/[General settings]/[Select
language]/[日本語].
Note
If a FOMA card is inserted, settings are saved to the FOMA card
as well. When the setting of the FOMA terminal handset and the
setting of the inserted FOMA card are different, the setting in the
FOMA card is prioritized.
56
Initial setting
Making the initial setting
The initial settings screen appears automatically when the
power is turned on for the first time. Each setting item can
also be set from Menu (When the initial settings are
complete, the stand-by display appears).
Date and time settings
Key/Standby i-motion
Font size settings
When items that have not been set remain, the setting screen
appears every time the power is turned on.
1
Set the date and time (nP. 57).
Set the date and time from 00:00 January 1, 2001 to 23:59
December 31, 2050.
2
Register a terminal security code (nP. 129).
3
Set the Key/Standby i-motion (nP. 110).
4
Set GPS Location provision ON/OFF (nP. 273).
5
Set the font size (nP. 124).
When the initial settings are complete, the software update
function confirmation screen appears. Read the description and
select [Agree] (When the initial settings are made from the
menu or the software update is set to other than [auto-update],
the confirmation screen does not appear).
Note
Press H to cancel the initial settings.
Change terminal security code
Location provision