Turning The Power On And Off - Sharp sh906i Before Using

Checking the battery level with sound and display
1
In the Custom menu, select [Settings]/[General
settings]/[Check status]/[Battery level].
Graphic
Sound Three beeps
Battery is
Status sufficiently full.
Wait approximately 2 seconds and the display disappears.
The battery level sound is heard at the volume set in Key/
Standby i-motion (nP. 110).
If the battery runs out
[Battery empty. Unsaved data will be lost. Ending
current operation] appears if battery starts to run out
(Press t to clear the message). After a while, an
alert tone sounds. The warning screen stating that
the battery runs out appears, handset operations are disabled and
power turns off after approximately 60 seconds.
During a voice/Videophone call, the alert tone sounds and [Battery
empty. Unsaved data will be lost. Ending current operation]
appears. The call is disconnected after approximately 20 seconds.
At the same time, the screen above appears and after
approximately 60 seconds, the power turns off.
Alert tone does not sound when Manner mode or Public mode
(Drive mode) is set (Alert tone sounds during a call).
Two beeps One beep
Battery is Battery is almost
running low. empty. Charge
the battery.
Power ON/OFF

Turning the power on and off

Turning the power on
1
Press H (for 2+ seconds).
It may take some time for the wakeup
screen to appear.
The wakeup screen appears followed by the
initial settings screen. Proceed to Initial
setting (nP. 56).
If initial settings have been completed, the
screen shown on the right appears when
power is turned on. This screen is called the
"stand-by display".
Welcome mail
"Welcome$SH906i%&" is saved by
default.
To check a welcome mail: In stand-by, press
t/select the stock icon C (mail
message)/t.
• For details on the following operations
nP. 209
Note
If initial settings are not yet completed, the setting screen appears
every time the power is turned on.
If the FOMA card is not inserted, [Insert UIM] and a FOMA card
error appear (nP. 37).
When [Enter PIN1 code] appears, enter the PIN1 code
(nP. 131).
Initial settings
screen
Stand-by display
Continued on next page
55