Click Switch Features; Safety Instructions And Warnings - NETGEAR GSS108E Hardware Installation Manual

ProSAFE 8-Port and 16-Port Gigabit Web Managed Click Switch

Click Switch Features

The click switches provide traffic management and multicast efficiency.
• Traffic management
- Auto-negotiation of speed and duplex modes
- 802.3x flow control
- DHCP client
- Dynamic MAC address management to prevent flooding (if packets are not received
from the same MAC address after 300 seconds, that MAC address is aged out)
- IEEE 802.1Q–based or port-based VLAN
- QoS based on weighted round robin (WRR)
- Port-based and IEEE 802.1p–based Quality of Service (QoS)
- QoS based on Type of Service (ToS)
- DSCP support
- Rate limiting
• Multicast efficiency
- IGMP snooping, v1, v2 and v3 (source filtering not supported)
- Blocking of unknown multicast traffic
- Static multicast router port
Certain features such as USB charging ports, link aggregation, and PoE ports are available
in specific switch models, as follows:
• USB charging ports. See
• Link aggregation. For the GSS116E and GSS108EPP, see
page 20.
• PoE ports. See

Safety Instructions and Warnings

Use the following safety guidelines to ensure your own personal safety and to help protect
your system from potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment,
observe the following precautions:
• This product is designed for indoor use only in a temperature-controlled (32-104°F,
0–40°C) and humidity-controlled (10–90 percent relative humidity) environment.
Any device that is located outdoors and connected to this product must be properly
grounded and surge protected.
Use the GSS108E Switch USB Charging Ports
Connect PoE Devices to the GSS108EPP Switch
Overview
Set Up Link Aggregation
5
on page 19.
on
on page 20.