Table of Contents
Advertisement
CALIBER B-VENT INSTALLATION INSTRUCTIONS
To determine whether your appliance is an intermittent pilot
ignition or a standing pilot ignition system, open the control
access panel to examine the wiring system. If your system
has a red ignitor button as shown in Figure 27, you own a
standing pilot ignition appliance. If no red ignitor button is
present, you own an intermittent pilot ignition appliance.
You may also check the rating label located on the inside of the
control access panel to determine ignition type.
1. Intermittent Pilot Ignition
f i r e - p a r t s . c o m
WARNING!
If you do not follow these instructions exactly, a fire or explosion may result causing property
A.
This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to
light the burner by hand.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the supplier's instructions.
•
If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in and turn the gas control knob. Never use tools. If the lever or knob will not move by hand, don't
try to repair it - call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any gas control which has been under water.
1.
STOP! Read the safety information above on this label.
2.
Turn wall switch to the "OFF" position.
3.
This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light burner by hand.
4.
Wait five minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above on this label.
If you don't smell gas, go on to the next step.
5.
To turn on burner, turn on all electric power to this appliance.
6.
If the appliance will not operate, follow the instructions "TO TURN OFF GAS TO APPLIANCE" and call your service technician
or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1.
Open the control access panel.
2.
Turn off the wall switch.
3.
Push in gas control knob and turn to the "OFF" position. Do not force.
4.
Close control access panel.
09/04
I. DETERMINE THE IGNITION
J. LIGHTING INSTRUCTIONS
FOR YOUR SAFETY
READ BEFORE OPERATING
damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
Figure 27 - Standing Pilot Ignition
31282 Rev Q
19
Hide quick links:
Advertisement
Table of Contents
