Motherboard Spares Part Number And System Maintenance Switch; Dimm Locations - HP StoreOnce 3100 Maintenance And Service Manual

Hide thumbs Also See for StoreOnce 3100:

System installation and configuration manual (73 pages)

Table Of Contents

Table of Contents

the remaining four slots may be configured with 10GbE network and/or Fibre Channel cards. Make a note

of the configuration and be sure to reinstall the cards in the exact same slots.

•

HPE StoreOnce 5100 System only: If Capacity Upgrade Kits are connected, make a note of the first in the

daisy chain sequence. The cabling must be reconnected from the SAS controller card to the correct

Capacity Upgrade Kit for the server.

Motherboard spares part number and System Maintenance

switch

The motherboard for the HPE StoreOnce 3100 System, HPE StoreOnce 3500, and 5100 System is the

standard DL360/DL380 Gen9 motherboard, spares part number 775400-001.

See the DL360p Gen 9 Maintenance and Service Guide and DL380p Gen 9 Maintenance and Service Guide

for more information about replacing the motherboard.

IMPORTANT:

There is a default boot mode setting on the system maintenance switch on the motherboard, which must

be set to Legacy and not be UEFI mode enabled (the BIOS/RBSU boot mode setting is also set to

Legacy).

The following drawing shows a ProLiant DL380 motherboard; the location of the System Maintenance switch

is the same for the ProLiant DL360 motherboard. The default value for all positions on the System

Maintenance switch is OFF. The S7 position must be set to ON for HPE StoreOnce systems.

1 2 3 4 5 6

C G K D H L

Ch 3

Ch 4

Figure 14: Location of the system maintenance switch

DIMM locations

DIMM slots are numbered sequentially (1 to 12) for each processor. The supported AMP modes use the letter

assignments for population guidelines.

7 8 9 10 11 12

1 2 3 4 5 6

J F B I E A

C G K D H L

Ch 2

Ch 1

Ch 3

Ch 4