Settings; Changing Direction Of Rotation [1-3]; Tool Holder, Attachments; Bit Holder - Festool DWC 18-2500 Instruction Manual

WARNING
Risk of injury

Always switch off the machine before adjusting

settings!

WARNING
Risk of injury

Always disconnect the battery pack before per-
forming any type of work on the machine!

Bit holder

The bit holder is used for fast replacement of bits.
CAUTION
Hot and sharp tools
Risk of injury

Wear protective gloves.
Bit holder assembly

Set the switch [1-4] into MAN position.

Set the bit holder [5-2] completely to the hexag-
onal spindle opening [5-3].

Attach bit [5-1] into the holder.

Then attach the depth stop on the gear box as
specified in chapter Depth stop.
5a

Tool holder, attachments

5-2
5-1
5-3
Settings

Changing direction of rotation [1-3]

• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
Bit holder disassembly

Remove the depth stop as specified in chapter
Depth stop.

Use power to pull out the holder from the spin-
dle opening.
You can use the depth stop [1-5] for the bit [1-6] re-
placement.

Attach the depth stop on the bit (see figure [5b].

By means of jamming the depth stop with the bit
and concurrent pulling, it is possible to pull out
the bit.

Then attach a new bit in the holder.
5b
MAN

Bit replacement

13