Replacing The Dell Logo Board; Procedure; Post-Requisites - Dell Embedded Box PC5000 Service Manual

Replacing the Dell logo board

WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box
Embedded Box PC, follow the steps in
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.

Procedure

1 Place the Dell logo board into the front chassis.
2 Replace the screws that secure the Dell logo board to the chassis.
3 Align the screw holes on the left chassis with the screw holes on the front
chassis.
4 Replace the screws that secure the left chassis to the front chassis.

Post-requisites

1 Replace the CPU
2 Follow step 2 to step 6 in
3 Replace the power
4 Replace the riser
5 Replace the heat
6 Replace the memory
7 Replace the bottom
8 Replace the intrusion
9 Replace the SIM
10 Replace the CANbus card
11 Replace the WWAN-antenna
12 Replace the WLAN
13 Replace the WLAN-antenna
14 Replace the PCI/PCIe card
132
board.
Replacing the top
connectors.
card.
sink.
module.
cover.
switch.
card.
or WWAN
connectors.
card.
connectors.
(if necessary).
PC. After working inside your
After working inside your Embedded
cover.
card.