Removing The Canbus Cable; Prerequisites; Procedure - Dell Embedded Box PC5000 Service Manual

Removing the CANbus cable

WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box
Embedded Box PC, follow the steps in
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.

Prerequisites

1 Follow step 1 to step 6 in
2 Remove the PCI/PCIe card

Procedure

1 Disconnect the CANbus cable from the connector on the CANbus card.
2 Remove the CANbus cable from the routing guides on the chassis.
3 Slide the cable out from under the heat sink pipe.
4 Remove the hexagonal screws that secure the CANbus port to the top cover.
After working inside your Embedded
"Removing the back
(if installed).
PC. After working inside your
cover".
77