Removing The Power Connectors; Prerequisites; Procedure - Dell Embedded Box PC5000 Service Manual

Removing the power connectors

WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box
Embedded Box PC, follow the steps in
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.

Prerequisites

1 Follow step 1 to step 6 in
2 Remove the PCI/PCIe card
3 Remove the heat

Procedure

1 Remove the nut and washer that secure the barrel connector to the chassis.
2 Push the barrel connector through the slot chassis.
3 Remove the screw that secures the grounding cable to the system board.
4 Disconnect the power cable from the system board.
"Removing the back
(if installed).
sink.
PC. After working inside your
After working inside your Embedded
cover".
105