Turning The System Over To The User; To The Installer - ADEMCO VISTA-100 Isntallation Instructions And Programming Manual

VISTA-100 Installation Instructions
• Fire trouble on any zone (zone response types 9, 16, 17, 18, 19)
• Fire supervisory present (zone response type 18)
• Unrestored fire alarm on any zone
• Bypass of any fire zone
• Bell circuit fault for any supervised fire bell
• Bypass/disable of any supervised fire bell
• Telco fault of either dialer line
• Bypass/disable of either dialer
• Earth ground fault present
• Bypass of earth ground supervisory zone
• Fault on LORRA "XMIT OK" signal (if it is enabled)
• LORRA trigger bypassed
• AC failure
• Low system battery
• Keypad supervision fault
This report will be sent as follows:
Contact ID:
High Speed:
Low Speed:
Power Failure
If the POWER indicator is off, and the message "AC LOSS" is displayed, the keypad is
operating on battery power only. Check to see that the circuit breaker for the branch circuit
to which your system's transformer is wired has not been accidentally turned off. Instruct
the user to call a service representative immediately if AC power cannot be restored.

Turning the System Over to the User

Before you turn the system over to the user, fully explain the operation of the system to the
user by going over each of its functions. Review the User's Manual with the users.
In particular, explain the operation of each zone (entry/exit, perimeter, interior, fire, etc.). Be
sure the user understands how to operate any emergency feature(s) programmed into the
system.

To the Installer

Regular maintenance and inspection (at least annually) by the installer and frequent testing
by the user are vital to continuous satisfactory operation of any alarm system.
You should assume the responsibility of developing and offering a regular maintenance
program to the user as well as acquainting the user with the proper operation and
limitations of the alarm system and its component parts. Include recommendations for a
specific program of frequent testing (at least weekly) to ensure the system's proper
operation at all times.
29-8
Code 608
Channel 3 of system report used (channel 9=6)
Digits programmed in System Group #4 report codes (#93 Report Code
Programming Mode).