HP 5920 series Configuration Manual page 40

[BEB1-Ten-GigabitEthernet1/0/1] spbm enable
[BEB1-Ten-GigabitEthernet1/0/1] port link-type trunk
[BEB1-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10
[BEB1-Ten-GigabitEthernet1/0/1] quit
[BEB1] interface ten-gigabitethernet 1/0/3
[BEB1-Ten-GigabitEthernet1/0/3] spbm enable
[BEB1-Ten-GigabitEthernet1/0/3] port link-type trunk
[BEB1-Ten-GigabitEthernet1/0/3] port trunk permit vlan 10
[BEB1-Ten-GigabitEthernet1/0/3] quit
# Repeat the previous steps to configure the MST parameters and SPBM function on all other BEBs
and BCBs. (Details not shown.)
NOTE:
On BCBs, you must enable SPBM on all the ports in the SPBM network.
2. Map B-VLAN 10 to ECT algorithm 3:
# Map B-VLAN 10 to ECT algorithm 3 on BEB 1.
[BEB1] spbm
[BEB1-spbm] ect 3 b-vlan 10
[BEB1-spbm] quit
# Repeat the previous step to map B-VLAN 10 to ECT algorithm 3 on all other BEBs and BCBs.
(Details not shown.)
3. Configure the Ethernet service instance for C-VLAN 100 on the customer edge port on BEB 1:
# Enable L2VPN.
[BEB1] l2vpn enable
# Create an SPB VSI (I-SID 1000) for Web traffic.
[BEB1] vsi web
[BEB1-vsi-web] spb i-sid 1000
# Assign B-VLAN 10 to the SPB VSI.
[BEB1-vsi-web-1000] b-vlan 10
# Enable tandem multicast replication mode for the SPB VSI.
[BEB1-vsi-web-1000] multicast replicate-mode tandem
[BEB1-vsi-web-1000] quit
[BEB1-vsi-web] quit
# Create Ethernet service instance 1, assign C-VLAN 100 to this instance, and map the service
instance to the SPB VSI.
[BEB1] interface ten-gigabitethernet 1/0/2
[BEB1-Ten-GigabitEthernet1/0/2] port link-type trunk
[BEB1-Ten-GigabitEthernet1/0/2] port trunk permit vlan 100
[BEB1-Ten-GigabitEthernet1/0/2] service-instance 1
[BEB1-Ten-GigabitEthernet1/0/2-srv1] encapsulation s-vid 100
[BEB1-Ten-GigabitEthernet1/0/2-srv1] xconnect vsi web
[BEB1-Ten-GigabitEthernet1/0/2-srv1] quit
[BEB1] quit
# Repeat the previous step to configure the Ethernet service instance for C-VLAN 100 on all other
BEBs. (Details not shown.)
36