HP 5920 series Configuration Manual page 39

Figure 10 Network diagram
XGE1/0/2
VLAN 100
Site 2
BEB
BEB 1
BEB 2
BEB 3
Configuration procedure
1. Configure basic SPBM parameters:
# Create VLAN 100 and B-VLAN 10.
<BEB1> system-view
[BEB1] vlan 100
[BEB1-vlan100] quit
[BEB1] vlan 10
[BEB1-vlan10] quit
# Configure MST region parameters on BEB 1. Make sure B-VLAN 10 is mapped to MSTI 4092.
[BEB1] stp region-configuration
[BEB1-mst-region] instance 4092 vlan 10
[BEB1-mst-region] region-name spbm
[BEB1-mst-region] active region-configuration
[BEB1-mst-region] quit
# Enable SPBM both globally and on the provider network ports on BEB 1, and assign the provider
network ports to VLAN 10.
[BEB1] spbm
[BEB1-spbm] quit
[BEB1] interface ten-gigabitethernet 1/0/1
VLAN 100
Site 1
XGE1/0/1
XGE1/0/1
BCB 1
XGE1/0/2 XGE1/0/3
XGE1/0/1
XGE1/0/3
SPBM network
BEB 2
B-MAC
0011.2200.1101
0011.2200.1201
0011.2200.1301
XGE1/0/2
BEB 1
XGE1/0/3
XGE1/0/1
BCB 2
XGE1/0/2
XGE1/0/3
XGE1/0/1
XGE1/0/3
XGE1/0/2
BEB 3
BCB
BCB 1
BCB 2
35
VLAN 100
Site 3
B-MAC
0011.2200.1401
0011.2200.1501