Related Manuals for Remington HC5870AU
Summary of Contents for Remington HC5870AU
- Page 1 BARBER’S BEST HAIR CLIPPER USE & CARE MANUAL PLEASE READ PRIOR TO USE To register your product go to www.remington-products.com.au 5 YEAR WARRANTY HC5870AU...
-
Page 2: Important Safety Instructions
Unplug and switch off this appliance before cleaning it. • Use this appliance only for its intended use as described in this manual. • Do not use attachments not recommended by Remington. • Never drop or insert any object into any opening of this appliance. •... - Page 3 PA-0510A (for Australia) with the output capacity of 5.0V dc; 1A (adaptor output). WARNING - KEEP THE APPLIANCE DRY Remington strongly recommends that an approved Safety Switch (Residual current device) be installed to protect all bathroom power outlets. Ask an electrical contractor for advice.
-
Page 4: Key Parts
HC5870AU BARBER’S BEST HAIR CLIPPER USE AND CARE MANUAL Thank you for purchasing your Remington® Barber’s Best Hair Clipper. Inside this manual you will find instructions on using and caring for your new hair clipper. KEY PARTS Removable Hair Clipper Blade •... - Page 5 ABOUT YOUR HAIR CLIPPER HC5870AU SPECIFICATIONS Power System Cordless (Rechargeable) Initial Charge Time 24 Hours Full Charge Time 4 Hours Runtime 60 Minutes Indicators LED Charging Indicator Voltage Type (adaptor voltage Worldwide 100-240V type) CHARGING • Before using your hair clipper for the first time, charge it for 24 hours. Note during this charge ignore the electronic indicators as they are in “start-up cycle”.
-
Page 6: Cleaning And Maintenance
CLEANING AND MAINTENANCE AFTER EACH USE: Brush the accumulated hair from the cutters. DO NOT SUBMERGE THE HAIR CLIPPER IN WATER. • Hold the clipper so that you are looking at its back (rubber housing), locate the blade release tab indentation at the base of the blade and push it inwards (towards the cutting blades) with your thumb. - Page 7 TIPS FOR A BARBER’S BEST HAIR CUT TIPS FOR BEST RESULTS • For even cutting, allow the guide comb/blade to cut its way through the hair. Do not force it through quickly. If you are cutting for the first time, start with the maximum guide comb, until you know how short you would like your hair to be.
-
Page 8: Battery Removal
3. Again, work the Head Trim-Shave blade all over the head, with angled and even strokes against the direction of hair growth. As this blade captures the shortest of hairs, you may be required to tap the tip of the blade throughout the shaving process to remove the small hairs that are captured in the blade. -
Page 9: Warranty Against Defects
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited WARRANTY AGAINST DEFECTS In this warranty: Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the Competition and Consumer Act 2010; CGA means the New Zealand Consumer Guarantees Act 1993; Goods means the product or equipment which was accompanied by this warranty and purchased in Australia or New Zealand, as the case may be;... - Page 10 New Zealand 0800 736 776 (toll free) AUTHORISED REPAIR CENTRES Visit www.remington-products.com.au for Authorised repair centre details. ® Registered Trade Mark of Spectrum Brands Inc. or one of its subsidiaries Made in China to the specifications of Spectrum Brands, Inc.