Table of Contents
Advertisement
Boiler sections/Connections
Push in the turbulators and mount the boiler door
3.
2.
4.
M 16
Flue gas connections
12
1.
1. 320 to 700 kW boilers: Push the
turbulators into the third heat ex
change tubes.
2. Mount the boiler door.
As delivered, the boiler door
swings out to the left. If necessary,
change over the hinges.
3. Secure the boiler door with the
M 16 screws.
4. Seal off the sight glass in the
boiler door.
1. Connect the flue outlet to the
chimney by means of flue pipes,
taking the shortest possible route
and at a gently rising angle.
Avoid sharp bends.
Flue outlet
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
320 to 1080 kW
. . . . . . . . . . . . . . . . . . . .
2. Position the measuring port (ap
prox. 10 mm dia.) at a distance
equal to two to three times the di
ameter of the flue pipe down
stream from the flue outlet.
3. Seal off the flue pipe.
Please note:
The joints in the flue pipe must be
gas-tight.
4. Insulate the flue pipe.
OD
300 mm
Advertisement
Table of Contents
