Table of Contents
Advertisement
Mounting the control unit
B 3.9 x 30
2.
1.
8.
4.
5.
¨ Caution!
Avoid kinks in the capillaries, other
wise correct functioning of the sen
sors cannot be guaranteed.
1. Push the rear part of the boiler
2. Screw the rear part of the control
3. Push the capillaries through the
4. Push the boiler temperature sen
3.
5. From the rear, push the boiler
6. Apply strain relief to the burner
7. Pull all cables from external equip
7.
6.
8. Position the facing panel so that
Insulation
control unit with the fastening
legs on the underside into the
front panel.
unit to the front panel with
B 3.9 x 30 self-tapping screws.
opening in the front panel and
push them as far as they will go
into the sensor well.
sor (supplied in the packing of
the control unit) as far as it will
go into the sensor well.
temperature sensor and the
burner cables through the open
ing in the front panel and
through the control unit to the
front.
cables in the rail.
ment to the front through the
openings in the rear panel and in
the front panel to the terminal
compartment of the control unit.
¨ Caution!
Run the cables so that they are
not subjected to excessively high
temperatures.
See installation instructions
for boiler control unit
the clip is on the left-hand side of
the front panel and snap home
on the right-hand side.
17
Advertisement
Table of Contents
