Fx 1N Run/Stop Control - Mitsubishi FX1N-14MR-ES/UL Hardware Manual

FX1N Series Programmable Controllers
3.2 FX RUN/STOP Control
1N
RUN or STOP of the FX
The RUN/STOP switch mounted next to the programming port.
A standard input (X0 to X17) defined by the system parameters.
Remotely from a personal computer or other programming peripheral.
Note:The FX
refer to the table below.
During remote operation the FX
recently operated control.
E.g. If the RUN/STOP switch is in RUN and a remote STOP is made from a personal
computer the RUN/STOP switch must be switched to STOP then back to RUN to
switch the MPU back to RUN mode.
Figure 3.2:RUN input terminal
➊
S/S 0V 24V
can be controlled by:
1N
RUN/STOP switch works in parallel with the RUN-input terminal. Please
1N
Table 3.2 : RUN/STOP selection
RUN
RUN/STOP
X0
SWITCH
RUN/STOP status is determined by the most
1N
➊
RUN INPUT
TERMINAL
✔ ✔
✔ ✘
✘ ✘
✘ ✔
Installation Notes 3.
FX MPU
1N
STATUS
RUN
RUN
STOP
RUN
3-4