Note For Using Expansion Board - Mitsubishi FX1N-14MR-ES/UL Hardware Manual

FX1N Series Programmable Controllers
1.4.2

Note for Using Expansion Board

The following conditions cannot be accomplished with an FX
- FX -422-BD + FX-2PIF
1N
- FX -5DM + FX
1N
- FX-10DM + FX
- Connect two Programming tools (FX-10P-E, FX-20P-E, Programming software, etc.)
- The use of Special function Blocks
Caution
Connect a programming tool (such as an FX-10P-E, FX-20P-E and personal computer) to
either the connector built in to the PLC or the connector on the FX
BD. If a programming tool is connected to both connectors, the program stored in the PLC
may not match the program stored in the programming tool. If the program is changed or the
set value of timers or counters are changed with this configuration, the program may be par-
tially overwritten and the PLC may malfunction.
-422-BD + FX-10DM
1N
-422-BD + FX-10DM
1N
Introduction 1.
PLC.
1S
-422-BD or FX
1N
1-13
1
2
3
4
-232-
1N
5
6
7