Command Output
PhyStatus
Protocol
Description
2.3 Device Maintenance
2.3.1 Device Maintenance Overview
Device maintenance mainly means device power-on, reset and power-off.
2.3.2 Device Maintenance Configuration
Device Power Up
l
Device Manual Power Up
Device manual power up means that enter boot menu to configure and start system
after powering up the device.
1. After the system powering up, enter Boot menu. In the first use, configure Boot as
follows: press any key to enter boot menu after the message "Hit any key to stop
autoboot" appears. Configure boot according to the following example. Load the
version after finishing the configuration.
2. Start the system manually after finishing the configuration.
3. System appears the prompt "ZXR10>" to indicate the starting is successful. Enter
enable command, and enter the enable password according to the prompt. Enter
privileged mode if passing the authentication.
Configuration Example
This example describes how to power on the system manually.
BootROM 1.20
Booting from NAND flash
High speed PHY - Version: 2.1.2 (COM-PHY-V20)
Update PEX Device ID 0x78260
High speed PHY - Ended Successfully
DDR3 Training Sequence - Ver 5.3.0
DDR3 Training Sequence - Run with PBS.
DDR3 Training Sequence - Ended Successfully
Status = MV_OK
BootROM: Image checksum verification PASSED
SJ-20150114102049-002|2015-01-15 (R1.0)
Chapter 2 System Management
Description
It indicates the interface physical state is available or not.
Up means available, and down means unavailable.
It indicates the link layer protocol is available or not. Up
means available, and down means unavailable.
Port description information
2-15
ZTE Proprietary and Confidential