Setting Aging Time Of Inactive Stream; Setting Sampling Rate; Setting Nm Server Address And L4 Port Id; Setting Source Address For Network Device - Zte ZXR10 8900 Series User Manual

ZXR10 8900 Series User Manual (Basic Configuration Volume)
Command
ip stream cache inactive <number>
ZXR10(config)#
Step Command
1
ZXR10(config)#
2
ZXR10(config-if)#
Command
ip stream export destination
ZXR10(config)#
<ip-address> udp-port
Command
ip stream export source <ip-address>
ZXR10(config)#
Step Command
1
ZXR10(config)#
number
2
ZXR10(config)#
number timeout-rate number
164 Confidential and Proprietary Information of ZTE CORPORATION

Setting Aging Time of Inactive Stream

If data of a flow are not updated within the specified time, the
aging information will be notified to stream record, in seconds, 15
seconds by default.

Setting Sampling Rate

interface < interface-name>
netflow-sample {ingress|egress }

Setting NM Server Address and L4 Port ID

Setting Source Address for Network Device

Sending Packets

Setting Template Refresh Rate

ip stream template refreh-rate
ip stream template refreh-rate
Functions
This sets aging time of inactive
stream.
Functions
This enters interface
configuration mode.
This configures packet
number-based IPFIX sampling
rate.
Functions
This sets the address and port id
of NM server, to which packets
are sent.
Functions
This sets source address for
network device sending packets.
Functions
This sets the number of
packets, after which template
packet is sent, 20 by default.
This sets template refresh
rate time, 30 minutes by
default.