Safety Features - Monessen Hearth AVFL42NTSC Installation & Operating Instructions Manual

AVFL Vent Free Fireplace
2. When the current setting is B), pressing TIMER button
and THERMO button at the same time for 3 seconds
will switch to A) Mode. The touch area icons will disap-
pear.
n Safety Features
1. Low Battery Detection
When low battery condition occurs, the trans-
mitter will turn off the fireplace.
A) Battery voltage is checked every one minute.
When the battery voltage is low, the LCD dis-
plays a low battery icon which will exist in all modes.
B) The transmitter will not operate with low battery
voltage. Change the batteries before the batteries
become too weak for normal operations.
2. Power On Initialization
After the power-on initialization, the transmitter sends
a signal to turn off the fireplace.
3. Thermal Shutdown
When the ambient temperature is more than 99°F, the
transmitter will turn off the fireplace.
A) The LCD will display "HI."
B) The Transmitter will not function until
the room temperature has dropped
below 99 degree Fahrenheit.
4. Low Temperature Condition
When the ambient temperature is less than 40 de-
grees Fahrenheit, the LCD will display
"LO," and NO SIGNAL will be sent to
turn on the appliance.
All functions still remain the same for
both Manual Mode and Thermostat
Mode.
5. Child-proof Protection
The child-proof icon will be shown when
the child-proof mode is activated by
pressing the ON button and the OFF
button at the same time for three sec-
onds.
A) Enter childproof mode by pressing and holding both
the ON button and the OFF button simultaneous-
ly for 3 seconds. The Childproof indicator will be
shown on the LCD.
B) Deactivate childproof mode by pressing and hold-
ing the ON button and the OFF button simultane-
ously for 3 seconds again. The Childproof indicator
disappears on the LCD.
C) The transmitter cannot be operated in childproof
mode.
Monessen • AVFL42 Installation Instructions • 20305467 Rev. B • 02/17
28
TOUCH SCREEN REMOTE CONTROL OPERATION
n Using the Mounting Base
The transmitter comes with a mounting base which allows
you to hang the transmitter on the wall.
1. Secure the mounting base
2. Hang the transmitter on
FP2612
low battery
FP2613
HI
FP2614
lo no child
on the wall with supplied
screws. For best viewing
angle, make it the same
height as your eyes.
the hook of the mounting
base, then push down so
the transmitter is flush to
the mounting base.
Figure 34
FP2674
mounting base