Final Installation; Bulb Installation - Monessen Hearth AVFL42NTSC Installation & Operating Instructions Manual

FINAL INSTALLATION

BULB INSTALLATION

Turn OFF the main power supply before perform-
ing any service work on the unit, including install-
ing or replacing light bulbs.
NOTE: This unit is shipped without bulbs installed to pre-
vent any damage to the bulb filament during transport.
This unit is shipped with a total of 13 bulbs (twelve 20W
bulbs and one 100W bulb). These instructions apply to
new installations only. If replacing bulbs after the installa-
tion is complete, see page 31 for instructions.
Figure 10–
Top Light Position; Porcelain Panel Screw Location
TOP LIGHT BULB INSTALLATION
1. Remove three screws holding light cover in place
(as shown in Figure 11)
2. Insert (1) 100W bulb provided into socket
3. Replace top light cover with three screws
Figure 11–
Top Light Screws
Monessen • AVFL42 Installation Instructions • 20305467 Rev. B • 02/17
Top light
location
Porcelain
panel screw
Light cover
screws
LOWER LIGHT BAR BULB INSTALLATION
1. Remove air deflection glass from the unit and place
on a flat, clean surface.
2. Using a Phillips screwdriver remove the screws (one
each) holding the left and right porcelain panels in
place.
3. Remove the retainer clips at bottom of porcelain
panels. Carefully remove the panels from the unit
placing them on a clean level surface. NOTE: The
rear porcelain panel is held in place by the left and
right panel and could fall forward if not supported
during removal of the side panels.
Figure 12–
Porcelain Panel Screw Location
4. With side panels removed the rear porcelain panel
can be removed from the unit and placed on a clean,
level surface.
5. Remove nine screws that secure the front hearth in
place and remove from unit. Figure 14
Figure 13–
Porcelain Panel Retainer Clip Location
AVFL Vent Free Fireplace
Porcelain
panel screw
Retainer clip
15