Programming Tool Applicability; Applicable Versions Of Programming Tool; In The Case Of Programming Tool (Version) Not Applicable; Program Transfer Speed And Programming Tool - Mitsubishi FX3G SERIES User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
5.2

Programming Tool Applicability

5.2.1

Applicable versions of programming tool

GX Developer is applicable to FX
Model name
(Media model name is
shown below.)
GX Developer
• SW D5C(F)-GPPW-J
• SW D5C(F)-GPPW-E
5.2.2

In the case of programming tool (version) not applicable

Inapplicable programming tools can programme by setting alternative model.
1. Alternative model setting
Model to be programmed
FX PLC
3G
*1. "FX " is selected when the FX-10P(-E) is used.
2N
2. Contents of restrictions
• Programming is enabled only in the function ranges such as instructions, device ranges and program sizes
available in a PLC selected as the alternative model.
• Use a programming tool that can select either FX
register capacity, etc.
• The built-in USB port cannot be used for programming communication.
5.2.3

Program transfer speed and programming tool

When either of the following interfaces is used for GX Developer (Ver.8.72A or later), writing and reading of
programs and monitoring of devices can be executed at high speed (115.2 kbps) in FX
1. Applicable interface
• Standard built-in port(RS-422) or function extension board FX
When the RS-232C/RS-422 converter FX-232AWC-H is connected
• Function extension board FX
• Special adapter FX
2. Communication speed setting by GX Developer
The communication speed can be set in the following position:
Select "Online"
3. In programming software not applicable to the FX
Communication is executed at 9,600 or 19,200 bps.
PLCs from the following version.
3G
Applicable
GX Developer version
Ver.8.72A or later
Model to be set
FX
3G
-232-BD for RS-232C
3G
-232ADP(-MB) for RS-232C
3U
"Transfer setup..." "PC side I/F", and double-click the "Serial" icon.
5 Version Information and Peripheral Equipment Connectability
FX PLC version
3G
Ver.1.00 or later
Model selection: FX
(First product)
Supports FX
The following instructions will be supported in the
Ver.1.10 or later near future
FLT(FNC49), ECMP(FNC110), EMOV(FNC112),
EADD(FNC120), ESUB(FNC121), EMUL(FNC122),
EDIV(FNC123), ESQR(FNC127), INT(FNC129)
*1
FX
1N
to change parameters, i.e. memory capacity, file
3G
-422-BD for RS-422
3G
Series
3G
5.2 Programming Tool Applicability
Description
3G
PLCs (Ver.1.10 or later).
3G
Priority High Low
*1
FX
2
FX
2N
PLCs.
3G
1
2
3
4
5
6
7
8
9
10
45