Advertisement
UPS Output Receptacles (Surge
Suppression Only)
Output AC Waveform (AC Mode)
Output AC Waveform (Battery Mode)
INPUT
Rated input current (Maximum Load)
Nominal Input Voltage(s) Supported
UPS Input Connection Type
UPS Input Cord Length (ft.)
UPS Input Cord Length (m)
Recommended Electrical Service
Input Phase
BATTERY
Full Load Runtime (min.)
Half Load Runtime (min.)
DC System Voltage (VDC)
Battery Recharge Rate (Included
Batteries)
Expandable Runtime
VOLTAGE REGULATION
Voltage Regulation Description
Undervoltage Correction
USER INTERFACE, ALERTS & CONTROLS
Front Panel LCD Display
Switches
Alarm Cancel Operation
Audible Alarm
LED Indicators
SURGE / NOISE SUPPRESSION
UPS AC Suppression Joule Rating
UPS AC Suppression Response
Time
4 UPS outlets, 4 surge-only outlets
Sine wave
PWM sine wave
12A
120V AC
5-15P; Right-Angled
6
1.8
15A 120V
Single-Phase
3 min. (500w)
10 min. (250w)
12
Less than 16 hours from 10% to 90%
No
Automatic voltage regulation (AVR) maintains line power operation with input voltage as low as 89
Input voltages between 89 and 104 are boosted by 14%
Backlighted LCD screen indicates input voltage, 5-bar battery charge level, overload, AVR, on battery and replace
battery status; LCD screen rotates for rack/tower viewing
2 Switches control off/on power status and alarm-cancel/self-test operation; dimmer switch controls LCD brightness
Power-fail alarm can be silenced using alarm-cancel switch; once silenced, alarm will re-sound to indicate
low-battery status
Audible alarm indicates power-failure and low-battery status; alarm can be disabled using PowerAlert software
Front panel LCD display
480
Instantaneous
3 / 5
Advertisement
